Wheelchair ramp installation in New Hampshire looks like the simple option until somebody works out the length. A ramp is the cheapest way to cover a few inches of rise and one of the hardest structures to fit on a village lot once the rise passes two feet. The slope rule does most of the deciding, and running that arithmetic first saves a great deal of time.
The Slope Rule Sets the Footprint
Accessibility standards call for a maximum slope of one inch of rise per twelve inches of run, and that ratio is the whole constraint. A 6 inch rise needs 6 feet of ramp. An 18 inch rise needs 18 feet. A 36 inch rise needs 36 feet.
Those figures cover the sloped surface alone. Standards also call for a level landing at the top and bottom, commonly five feet long, and an intermediate landing where the run passes 30 feet. A ramp longer than roughly 24 feet usually has to switch back to fit a residential lot, and each turn needs a platform of its own.
So a 30 inch rise does not need 30 feet of yard. With landings and a switchback it needs well over 100 square feet.
Landings, Turns, & Handrails
A level landing belongs at the top so somebody can stop, let go of the handrail, and open the door without holding position on a slope. The same applies at the bottom.
Where the ramp turns, the turn happens on a level platform rather than on the slope. A sloped turn is hard to manage in a manual chair and unsafe in winter.
Handrails run both sides on any ramp above a modest rise, and they need to be graspable rather than decorative. Edge protection along both sides stops a caster dropping off, which is the failure behind most ramp incidents.
Materials That Hold Up Here
Three material choices dominate, and the climate affects each differently.
Pressure-Treated Wood
Pressure-treated wood is the cheapest to build and the most common on New Hampshire homes. It needs a non-slip surface added, because wet or frosted decking is slick, and grip tape or grit paint both need renewing.
Aluminum Modular Sections
Aluminum modular ramps cost more up front and arrive as prefabricated sections bolted together on site. The surface sheds water and snow, installation takes a day rather than a week, and the structure can be dismantled and resold. For a temporary need this is usually the right choice.
Poured Concrete
Poured concrete lasts longest and suits low rises best. At any real length it becomes expensive, and it cannot be removed later without demolition.
Permits & Property Lines
Most New Hampshire towns require a building permit for a ramp of any size, and the ones that do not still generally want to see the plan.
Two things catch homeowners out. A ramp counts as a structure for setback purposes in many zoning ordinances, so a 30 foot run heading toward a side property line can hit a setback before it reaches its landing. And in a historic district, exterior alterations visible from the street may need review first.
Check both with the town before buying material. A ramp torn out and rebuilt in another direction is the most expensive version of this project.
Snow Load & Winter Clearing
This is the factor that gets left out of most ramp discussions and matters more here than almost anywhere.
The Clearing Burden
A 30 foot ramp is 30 feet of surface to clear of snow, sand, and keep free of ice before anybody can use it. That is a daily obligation for four or five months, and it tends to fall on the household least able to absorb it.
Ramp surfaces also hold meltwater that refreezes overnight, and an icy sloped surface is more hazardous than an icy flat one. A ramp facing north or sitting in shade stays frozen after the rest of the property has thawed.
Covers & Heat Cable
A roof over the ramp solves much of this and adds cost. Heat cable is another route and adds an electrical run. Neither is unusual on a well planned project.
Where a Ramp Stops Making Sense
Below roughly a foot of rise, a ramp is almost always the simpler and cheaper answer, and a threshold ramp handles a single step or a door sill with no installation at all.
Above two or three feet, three things turn against it. The structure outgrows the yard, the winter clearing burden becomes unmanageable, and a long run at the maximum gradient is tiring for a manual wheelchair user, which means the ramp gets built and then avoided.
That is where a vertical platform lift enters the conversation. A lift covering a 36 inch rise occupies roughly 12 to 16 square feet at the base rather than over 100.
Dealers who handle both sides of this give more useful advice than a contractor who only builds ramps. Stairlifts & Ramps of New England, a family-run accessibility dealer covering New Hampshire from offices in Salem and Meredith, works across entry access of this kind, and firms carrying both ramps and lifts have no particular reason to push a household toward the structure that happens to be their only product.
Funding Worth Checking First
Approvals take weeks, and most programs will not reimburse work that started before approval came through, so check before building rather than after.
VA Programs
Veterans should look at this carefully. The VA’s Home Improvements and Structural Alterations grant provides a lifetime benefit of up to $6,800 for service-connected disabilities, and permanent modular ramping does qualify, while the published exclusion list names portable ramps, porch lifts, and stair glides among items HISA does not fund. Confirm eligibility with the Prosthetic and Sensory Aids Service at a local VA medical center rather than any vendor summary.
Medicaid & Medicare
New Hampshire Medicaid waivers cover accessibility equipment for eligible participants, subject to assessment and funding. Medicare does not, since it classifies ramps as home modifications rather than durable medical equipment.
Start With the Rise
Measure from the finished ground surface to the top of the landing, then multiply by twelve. That single number tells you how much ramp the standards require.
Compare it against the usable yard in front of the entry, including what has to stay clear for the driveway and the walkway. If the number fits, a ramp is the straightforward answer. If it does not, you have learned that in ten minutes rather than after a contractor visit.

